You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 15 Next »

This document only applies to Armor Complete users.  

Create a L2L VPN tunnel with a new workload 

You must first create a workload before you can create an L2L VPN tunnel.

 

  1. In the Armor user interface, on the left-side navigation, click Infrastructure
  2. Click L2L VPN.
  3. If you have virtual machines in various data centers, then click the corresponding data center. 
  4. Click New L2L.
  5. In Tunnel Name, enter a descriptive name. 
  6. In Encryption Mode, select an encryption mode. You can select between Advanced Encryption Standard or Data Encryption Standard
  7. In Pre-Shared Key, click Generate or create your own key. You will use this key to securely connect to your local endpoint. 
    • If you create your own key, this key must contain the following requirements:
      • 16 to 96 characters
      • One lower-case letter
      • One upper-case letter
      • One number
  8. In Remote Peer IP Address, enter your network's IP address. 
  9. In Remote Host/Networks (CIDR), enter your host address.
  10. In Local Host/Networks (CIDR), enter your network's  
  11. Click Save L2L

  • Local Endpoint = ESG IP on the form is Remote Endpoint
  • Local Subnets = Remote Host Networks
  • Peer Endpoint = Local IP from form
  • Peer Subnets = Local Host Networks

Edit a L2L VPN tunnel

  1. In the Armor user interface, on the left-side navigation, click Infrastructure
  2. Click L2L VPN.
  3. If you have virtual machines in various data centers, then click the corresponding data center. 
  4. Click the gear icon that corresponds to the desired L2L VPN tunnel, and then select Edit
  5. Make your desired changes, and then click Save L2L



Enable, disable, or delete a L2L VPN tunnel

 

  1. In the Armor user interface, on the left-side navigation, click Infrastructure
  2. Click L2L VPN.
  3. If you have virtual machines in various data centers, then click the corresponding data center. 
  4. Click the gear icon that corresponds to the desired L2L VPN tunnel, and then select Enable, Disable, or Delete.